CADDX 8980

TO ARM:
Close all protected doors and windows, check for green ready light on keypad. Enter your code and red armed light will come on. Exit through delay entry exit door. If you do not exit within the delay time all interior zones will automatically bypass and the interior zone lights will be lit. If you wish to deactivate exit delay press the (*) key after the system is armed. Press the (*) key again to reactivate the exit delay.

TO DISARM:
Enter your 4 digit code in the keypad.

TO BYPASS:
With the system disarmed press the (*) key, zone #'s to be bypassed, and then the (*) key again.

TO SEND PANIC:
Press the (*) and (#) key together for 1 second.

TO SEND KEYPAD FIRE:
Press the (1) and (3) keys at the same time.

TO RESET:
Enter code to silence audible alarm and then press (#) key to reset.

KEYPAD BEEPING:
Each time a key is pressed on the keypad control a short beep will sound. If the keypad control beeps 3 times after code entry it has not accepted the code. Press (#) reset key and re-enter a valid code. If the keypad beeps continously after code entry it is a indication that the power light is off or of another trouble condition. The beep can be silenced by entereing the 4 digit code. If the power light is out you should restore power if possible. If the power light is on, press the (#) reset key, wait 10 seconds and re-enter your 4 digit code. If you are unable to correct the trouble condition the call for service.

TO CHANGE MASTER CODE:
If the master code is (1)(2)(3)(4) and you want to change it to (5)(3)(4)(2), the sequence would be as follows; press (*)(1)(#). This enters programing for user code #1. Then (1)(2)(3)(4) old master code. Press (*)(1)(#). Verifying that user code #1 is being changed, Then new code (5)(3)(4)(2). Now end this sequence by pressing (#)(1)(#) to exit programing. The 17 key sequence is as follows; (*)(1)(#)(1)(2)(3)(4)(*)(1)(#)(5)(3)(4)(2)(*)(1)(#)

TO ADD USER CODES:
To program user code #2 would be as follows (*)(2)(#)(*)(2)(#)(*)(2)(#). To remove user code simply program it to be the master code. ex;(*)(2)(#) (mastercode)(*)(2) (#)(master code)(*)(2)(#). User code #2 has now been deleted.