NAPCO MA 800

MA 800
DISARM:
Enter code at keypad. If error is made wait 5 seconds before re-entering.

TO ARM:
Close all protected doors and windows, even the door nearest the keypad. Wait for the solid green light and enter your code. Wait for solid red light and exit within 30 seconds.

TO FIND OPEN ZONE:
Green light will flash. Count the number of flashes to determine open zone.

RESET BURGLAR ALARM:
Enter code at keypad twice

TO BYPASS:
System only able to bypass all motions at once. Press (S) & yellow light will come on. Enter code for red and yellow lights to come on together.

TO RESET SMOKE/FIRE ALARM:
Enter code twice to silence. Open alarm cabinet door, wait 5 seconds and then close and lock it. If this does not work (for earlier version) open the cabinet and locate, in upper right of the green circuit board, two glass fuses with metal ends. Remove fuses with fingers, wait 5 seconds, and put fuses back into place.

TO CHANGE CODE:
Open alarm cabinet door and locate black slide switch in upper left corner. Slide switch to far right from (normally) center position. Enter your new code (2-6 digits) at keypad. Note; nothing noticeable will happen. Go back to cabinet & slide switch back to center.